12v Gear Motor PWM Variable Speed 12vdc Gearmotor

This is a brand new electric gear motor that has an extremely high torque and is speed adjustable with a PWM (Pulse Width
Modulating) controller.  The gear motor is measured to be 7 inch long and the motor itself has a diameter of 2.5 inches.  Drive
shaft is 10mm in diameter with 2 flats where flat to flat is 6mm.  The shaft has a threaded end that is to fit a M6 tightening nut.  
Rated voltage of this gear motor is 13.5 VDC and maximum speed is 50 RPM.  Rated output load is 60 watts and output
toruqe at 50 RPM is 11.5 N-m (8.5 ft-lb).  Mounting is based on M6 screw mounting.  The 12V DC PWM controller features a 5
inches(12.7 cm) long connection to its potentiometer.  The potentiometer has a on/off switch built-in with a knob.  An overload
protection is set at 6 amps of current so the controller will shut down when such a current occurs.   There are connectors
between the gear motor and the controller.  To run the gear motor in CW rotation, please connect motor's green connector to
controller's red connector and motor's red connector to controller's black connector.  To run the gear motor in CCW rotation,
please connect motor's green connector to controller's black connector and motor's red connector to controller's red
connector.  The distance of the connection wires between the motor and the controller is 10 inches(25.4 cm).  The distance of
the 12v connection wire is 46 in(116.8 cm) long.  
PART NUMBER:  PN00409
WONDERMOTOR
YOUR SOURCE OF HIGH QUALITY MOTORS
[ E-mail:  sales@wondermotor.com ] [ Phone:  626.322.9220 ]
[ Discussion Home Page ]      |      [ Product Home Page ]
Our products are available to be purchased online.  Please simply click on the product(s) that you wish to
order below for more information.  For products that are listed here but not found in our online store, simply
e-mail or call us to request for your order(s).  We also welcome wholesale/resale buyers.  [ Privacy Policy ]
$89.95